pages 46-7.
*******Copy*******************
Replacing tail/brake/turn signal/backup lamp bulbs
The tail/brake/turn signal and backup lamp bulbs are located in the tail
lamp assembly. Follow the same steps to replace either bulb.
1. Make sure the headlamp switch is in the OFF position and open the
trunk.
2. Lift out trunk floor carpeting panel to access a Luggage Scuff Plate
(Hard Molding) shingles and a Trunk Side Panel (dark grey, soft
wheelhouse side trim panel) at the lamp area.
3. Carefully pull/push the Trunk Side Panel (dark grey, soft wheelhouse
side trim panel) outboard to expose the lamp assembly. The most
effective point to grasp the Trunk Side Panel when pulling it out from
the Luggage Scuff Plate is at it檚 bottom edge where that edge meets the
exposed sheet metal of the trunk floor.
Note: Do not allow the Trunk Side Panel to remain bent and untucked
from the Luggage Scuff Plate (hard molding) for a long period of time.
Doing so may result in permanent deformation.
4. Remove the bulb socket by
turning it counterclockwise and
pulling it straight out.
5. Pull the bulb from the socket and
push in the new bulb.
6. Install the bulb socket into the
lamp assembly by rotating it
clockwise.
7. Carefully push the Trunk Side
Panel (dark grey, soft wheelhouse
side trim panel) back to the shingle position to the Luggage Scuff Plate
(hard molding).
8. Install trunk floor carpeting panel.
******End Copy*********
You CAN do it yourself. Just follow ^these instructions.
I hope this helps
;-)
How to change the rear right turn signal in a 2006 ford fusion.See?
I knew you could do it!
Independence is empowering huh? LOL
(Thank you for choosing a Best Answer too!)
Report Abuse
How to change the rear right turn signal in a 2006 ford fusion.I think on the fusion you need to remove the rear light lens to be able to get at the bulbs.
No comments:
Post a Comment